1 files changed, 17 insertions, 2 deletions
diff --git a/doc/imfile.html b/doc/imfile.html
index 89be3292..60bbbeea 100644
--- a/doc/imfile.html
+++ b/doc/imfile.html
@@ -86,8 +86,8 @@ level may be needed. Even if you need quick response, 1 seconds should
 be well enough. Please note that imfile keeps reading files as long as
 there is any data in them. So a "polling sleep" will only happen when
 nothing is left to be processed.</li>
-<li><b>$InputFilePersistStateInterval </b> [lines]</b><br>
-Available in 4.7.3+<br>
+<li><b>$InputFilePersistStateInterval</b> [lines]</b><br>
+Available in 4.7.3+, 5.6.2+<br>
 Specifies how often the state file shall be written when processing the input
 file. The default value is 0, which means a new state file is only written when 
 the monitored files is being closed (end of rsyslogd execution). Any other
@@ -96,6 +96,21 @@ been processed. This setting can be used to guard against message duplication du
 to fatal errors (like power fail). Note that this setting affects imfile
 performance, especially when set to a low value. Frequently writing the state
 file is very time consuming.
+<li><b>$InputFileReadMode</b> [mode]</b><br>
+Available in 5.7.5+
+<li><b>$InputFileMaxLinesAtOnce</b> [number]</b><br>
+Available in 5.9.0+
+<br>
+This is useful if multiple files need to be monitored. If set to 0, each file
+will be fully processed and then processing switches to the next file
+(this was the default in previous versions). If it is set, a maximum of
+[number] lines is processed in sequence for each file, and then the file is
+switched. This provides a kind of mutiplexing the load of multiple files and
+probably leads to a more natural distribution of events when multiple busy files
+are monitored. The default is 10240.
+<li>$InputFileBindRuleset &lt;ruleset&gt;<br>
+Available in 5.7.5+, 6.1.5+
+Binds the listener to a specific <a href="multi_ruleset.html">ruleset</a>.</li>
 </ul>
 <b>Caveats/Known Bugs:</b>
 <p>So far, only 100 files can be monitored. If more are needed,