diff options
Diffstat (limited to 'doc/imtcp.html')
| -rw-r--r-- | doc/imtcp.html | 15 |
1 files changed, 9 insertions, 6 deletions
diff --git a/doc/imtcp.html b/doc/imtcp.html index feb0bdd7..5ac30d08 100644 --- a/doc/imtcp.html +++ b/doc/imtcp.html @@ -17,10 +17,6 @@ Encryption is natively provided by selecting the approprioate network stream driver and can also be provided by using <a href="rsyslog_stunnel.html">stunnel</a> (an alternative is the use the <a href="imgssapi.html">imgssapi</a> module).</p> -<p>Multiple receivers may be configured by specifying -$InputTCPServerRun multiple times. This is available since version 4.3.1, earlier -versions do NOT support it. -</p> <p><b>Configuration Directives</b>:</p> <p><b>Global Directives</b>:</p> @@ -67,13 +63,13 @@ the sender is throttled a bit when the queue becomes near-full. This is done in to preserve some queue space for inputs that can not throttle (like UDP), but it may have some undesired effect in some configurations. Still, we consider this as a useful setting and thus it is the default. To turn the handling off, simply -configure that explicitely. +configure that explicitly. </li> <li><b>MaxListeners</b> <number><br> Sets the maximum number of listeners (server ports) supported. Default is 20. This must be set before the first $InputTCPServerRun directive.</li> <li><b>MaxSessions</b> <number><br> Sets the maximum number of sessions supported. Default is 200. This must be set before the first $InputTCPServerRun directive</li> <li><b>StreamDriver.Mode</b> <number><br> -Sets the driver mode for the currently selected <a href="netstream.html">network stream driver</a>. <number> is driver specifc.</li> +Sets the driver mode for the currently selected <a href="netstream.html">network stream driver</a>. <number> is driver specific.</li> <li><b>StreamDriver.AuthMode</b> <mode-string><br> Sets the authentication mode for the currently selected <a href="netstream.html">network stream driver</a>. <mode-string> is driver specifc.</li> <li><b>PermittedPeer</b> <id-string><br> @@ -100,6 +96,13 @@ activated. This is the default and should be left unchanged until you know very well what you do. It may be useful to turn it off, if you know this framing is not used and some senders emit multi-line messages into the message stream. </li> +<li><b>RateLimit.Interval</b> [number] - (available since 7.3.1) specifies the rate-limiting +interval in seconds. Default value is 0, which turns off rate limiting. Set it to a number +of seconds (5 recommended) to activate rate-limiting. +</li> +<li><b>RateLimit.Burst</b> [number] - (available since 7.3.1) specifies the rate-limiting +burst in number of messages. Default is 10,000. +</li> </ul> <b>Caveats/Known Bugs:</b> <ul> |