General Queue Parameters

Queue parameters can be used together with the following statements:

• action()
• ruleset()
• main_queue()

Queues need to be configured in the action or ruleset it should affect. If nothing is configured, default values will be used. Thus, the default ruleset has only the default main queue. Specific Action queues are not set up by default.

• queue.filename name
  File name to be used for the queue files. Please note that this is actually just the file name. A directory can NOT be specified in this paramter. If the files shall be created in a specific directory, specify queue.spoolDirectory for this. The filename is used to build to complete path for queue files.
• queue.spoolDirectory name
  This is the directory into which queue files will be stored. Note that the directory must exist, it is NOT automatically created by rsyslog. If no spoolDirectory is specified, the work directory is used.
• queue.size number
  This is the maximum size of the queue in number of messages. Note that setting the queue size to very small values (roughly below 100 messages) is not supported and can lead to unpredictable results.
  For more information on the current status of this restriction see the rsyslog FAQ: "lower bound for queue sizes".
• queue.dequeuebatchsize number
  default 16
• queue.maxdiskspace number
• queue.highwatermark number
  default 8000
• queue.lowwatermark number
  default 2000
• queue.fulldelaymark number
• queue.lightdelaymark number
• queue.discardmark number
  default 9750]
• queue.discardseverity number
  *numerical* severity! default 8 (nothing discarded)
• queue.checkpointinterval number
• queue.syncqueuefiles on/off
• queue.type [FixedArray/LinkedList/Direct/Disk]
• queue.workerthreads number
  number of worker threads, default 1, recommended 1
• queue.timeoutshutdown number
  number is timeout in ms (1000ms is 1sec!), default 0 (indefinite)
• queue.timeoutactioncompletion number
  number is timeout in ms (1000ms is 1sec!), default 1000, 0 means immediate!
• queue.timeoutenqueue number
  number is timeout in ms (1000ms is 1sec!), default 2000, 0 means indefinite
• queue.timeoutworkerthreadshutdown number
  number is timeout in ms (1000ms is 1sec!), default 60000 (1 minute)
• queue.workerthreadminimummessages number
  default 100
• queue.maxfilesize size_nbr
  default 1m
• queue.saveonshutdown on/off
• queue.dequeueslowdown number
  number is timeout in microseconds (1000000us is 1sec!), default 0 (no delay). Simple rate-limiting!
• queue.dequeuetimebegin number
• queue.dequeuetimeend number

Sample:

The following is a sample of a TCP forwarding action with its own queue.

This documentation is part of the rsyslog project.
Copyright © 2013 by Rainer Gerhards and Adiscon. Released under the GNU GPL version 3 or higher.